How to Use the Water Dispenser, Vegetables

18.The first time you require water out of the dispenser, there will be a delay while the water reservoir fills up.

19.Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir is flushed out. Failure to do this will result in excessive dripping from your dispenser.

Important!

•All connections must be checked for leaks.

•If unsure of connection process and/or leaks then contact your local plumber to install and check the system for you.

•Ensure white 6 mm (¼”) tubing is routed away from sharp objects, sharp corners (beware of kinking tube as this will stop water flow), clear of the refrigerator unit compartment and not in a location where it can be squashed.

•Ensure all push-fit connections are firmly pushed into place. The tube should push in 20 mm (¾”) before reaching the stop.

•If tubing is removed at any point, re-cut the end and re-insert. Tubing must be fully inserted to avoid leaks.

•To remove tube from connection points, turn off the isolating tap, push in the collet and gently pull tubing at the same time.

Fig.8 Connection to water supply

Diagram 9

Refer to page 26, About Freezer compartment, for instructions on the first use of the ice maker and water dispenser.