Haier GDE700AW Installation Instructions, Tools and materials required, Electrical requirements

English

INSTALLATION INSTRUCTIONS

•Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat sources, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer.

Tools and materials required

•Phillips head and flathead screwdrivers

•Channel-lock adjustable pilers

•1/2 inch open end wrench

•Carpenter’s level

•Measuring tape (12ft. min.)

•Duct tap

•Rigid or flexible metal 4 inch (102cm) duct

•Vent hood

Electrical requirements

U.S. Only

Power supply:

3 or 4 wire, 240 Volt, 30 Amp,60Hz, 1 Phase Power Supply Cord Kit (not supplied when sold in the United States) – Purchase to meet local electrical codes.

The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type SPDT RATED AT 240 Volt AC minimum, 30 Amp., with 3 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. If being installed in a manufactured (mobile) home,the dryer MUST employ a 4-conductor power supply cord. NEMA 14-30 type SRDT or ST (as required) rated at 240 Volt AC Minimum, 30 Amp., with 4 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. See Electrical Connections for A 4-Wire System.

Canada Only

Candian models are supplied with the appropriate power cord.

Unpacking Your Dryer

1.Remove all packaging material. This includes the foam base and all adhesive tape holding the dryer accessories inside and outside.

2.Inspect and remove any remains of packaging, tape or printed materials before using the dryer.

4