Haier HR-165 manual Unpacking, Check attachments and materials, Idle time

Refrigerator Diagram

3

4

1

5

2

1.Shelves

2.Vegetable and fruit tray 3.Temperature Controller 4.Egg tray

5.Bottle racks

This diagram may vary slightly with the layout of the refrigerator you have

just purchased due to technical improvements.

Preparation

Unpacking

Remove all packing materials.

Check attachments and materials

Checking should be conducted with reference to the Packing List. Contact the local distributor if discrepancies are found.

Ensure proper location of the refrigerator.

Clean the refrigerator before use.

(See the following section “Cleaning”)

Idle time

After the refrigerator has been sited and cleaned, let it stand for more than 30 minutes before connecting the power source

Left/Right Door Opening（Figure A）

The door of the refrigerator can be opened both from the left or right as required. The following are the steps required to position the door to open to the right.

1.Remove the door and place aside after removing the bracket (2) and the screw hole cover (3).

2.Remove the upper bracket (6) and the pivot pin (1) and the spring washer and re-fix to the corresponding position on the left. (Bracket cover (5) should also be moved to the corresponding left position.

3.Carefully place the door on the upper bracket (6) and lower bracket (2). Tighten the lower bracket screws to the refrigerator case.

4.Place the screw cover (3) over the original lower bracket hole on the right side.

5.Change the position of component (4) to the corresponding opposite position.

6.After installation open and close the door to ensure the door operates smoothly.

3 4