Troubleshooting
Visit www.goldlinecontrols.com for helpful information on operation, maintenance and troubleshooting your Aqua Rite® Electronic Chlorine Generator. You may also call for technical assistance at
1.Model and Serial # of control and cell
2.Date of installation
3.Installing Company or Dealer
4.Salt level
Diagnostic Displays
Sequential pushes of the small "diagnostic" button next to the LCD display will cause the Aqua Rite to display the following information:
1.Pool temperature (xx degrees Fahrenheit or Celsius)
2.Cell voltage (typically 22.0 to 25.0 volts when chlorine is being generated, other- wise
3.Cell current (typically 4.50 to 7.80 amps when chlorine is being generated, other- wise 0 amps)
4.Desired Output % ("0P"
5.Instant salinity (
6.Product name sent to the Jandy AquaLink RS display
7.Software revision level (r1.xx)
On the 8th push of the button the display will revert back to the default salt display. Also, if the button is not pushed for 30 seconds, the display will revert back to the standard salt display.
Common Problems and Solutions
1."Power" LED not on
Check to make sure either 120VAC or 240VAC input power is connected to the proper screw terminals at the Aqua Rite control. Verify input voltage with a voltme- ter. If there is input power, the fuse may have blown. The Aqua Rite is protected by a 20 amp slow blow fuse located on the bottom of the enclosure, next to the wiring knockouts.
2."Generating" LED flashing
The temperature of the pool water is too high or low to operate. You can override this by switching the main switch to SUPER CHLORINATE. The Aqua Rite will run at maximum output for the remainder of the current pump cycle or 24 hours, whichever comes first.
3."No Flow" LED illuminated
The Aqua Rite has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged. Make sure you have at least 12" of straight pipe before the flow switch. If there is adequate flow and the LED is still on, check that the arrows on the flow switch (on top of hex) are pointing in the direction of flow.
13
