Haier HSU-12HKAG(R2DB) Timer On/Off On-Off Operation, Health Operation, TURBO/QUIET Operation

Operation

Timer On/Off On-Off Operation

1.After unit starts, select your desired operation mode. 2.Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows:

Remote controller:

BLANK

0.5h	0.5h	0.5h	0.5h
TIMER ON	TIMER OFF	TIMER ON-OFF	TIMER OFF-ON

Then select your desired TIMER mode (TIMER ON or TIMER OFF or TIMER ON-OFF). " "or " "will flash.

3.Press / button to set time.

Press the button for each time, setting time in the first 12 hours increased by 0.5 hour every time, after 12 hours,increased by 1 hour every time.

Press the button for each time, settiing time in the first 12 hours decreased by 0.5 hour every time, after 12 hours,decreased by 1 hour every time.

It can be adjusted within 24 hours. 4.Confirm timer setting

After adjust the time,press button and confirm the time ON or OFF button will not flash any more. 5.Cancel timer setting

Press the timer button by times until the time display eliminated.

Hints:

After replacing batteries or a power failure happens, time setting should be reset.

According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can be achieved.

HEALTH Operation

(This function is unavailable on some models.)

Press button to enter additional options, when cycle

display to , will flash，and then press ,enter to

health function. When cancel the function, please enter additional options again and to cancel health function.

The anion generator in the airconditioner can generate a lot of anion effectively balance the quantity of position and anion in the air and also to kill bacteria and speed up the dust sediment in the room and finally clean the air in the room.

TURBO/QUIET Operation

(This function is unavailable on some models.)

(1)TURBO Operation

When you need rapid heating or cooling, you can use this function.

Press TURBO button, the remote controller will show , and then achieve to the turbo function. Press again this TURBO button , the turbo function will be cancelled.

(2)QUIET Operation

Press button to enter additional options, when cycle

display to , will flash，and then press ,enter to quiet function. When cancel the function, please enter additional options again and to cancel quiet function.

Note ：

During TURBO operation, in rapid COOL mode , the room will show inhomogeneous temperature distribution.

Long period QUIET operation will cause effect of not too cool or not too warm.

Emergency operation and test operation

Emergency Operation:					Pi
Use this operation only when the remote controller
is defective or lost.
When the emergency operation switch is
pressed,the" Pi "sound is heard once, which means
the start of this operation.
In this operation, the system automatically selects
the operation modes,cooling or fan or heat,according
to the room temperature.
Room	Operation	Designated	Timer	Air flow
temperature	mode	temperature	mode
ABOVE 23OC COOLING		26OC	NO	AUTOMATIC
BELOW 23OC	HEAT	23OC	NO	AUTOMATIC
(Cooling only uint）		Operation	Designated	Timer	Air flow
Room temperature		mode	temperature mode
BELOW 23OC		FAN	26OC	NO AUTOMATIC

It is not possible to operate in dry mode.

Test operation:

Test operation switch is the same as emergency switch. Use this switch in the test operation when the room temperature is below 16oC, do not use it in the

normal operation.	Pi Pi
Continue to press the test operation

switch for more than 5 seconds. After you hear the "Pi" sound twice,release your finger from the switch: the cooling operation starts with the air flow speed "Hi".

After 30 minutes, test operation ends automatically(Only for 22K,24K unit).

3