Haier HSU-18CKAS(R2DB) Operation, Loading of the battery, Unit start, Select temp.setting

Operation

Unit start / stop

Remote controller

1

3

2

2

1. Unit start

Press ON/OFF on the remote controller, unit starts.

2.Select temp.setting

Press	/		button
	Every time the button is pressed, temp.setting
	increase 1oC,if kept depressed, it will increase
	rapidly
	Every time the button is pressed, temp.setting
	decrease 1oC,if kept depressed, it will
	decrease	rapidly

Select a desired temperature.

3.Fan function

Remote controller A: Press FAN button.

Remote controller B:

Press button to enter additional options, when

cycle display to , will flash. And then press

enter to FAN function.

For each press	button fan speed
changes as follows:
Remote controller:
		Display
		circulated
LOW MED	HI	AUTO

Air conditioner is running under displayed fan speed. When FAN is set to AUTO, the air conditioner automatically adjusts the fan speed according to room temperature.

Operation	Display Board	Remote	Note
Mode		Controller	Under the mode of auto operation, air conditioner will
AUTO			automatically select Cool or Heat operation according
			to room temperature. When FAN is set to AUTO, the
			air conditioner automatically adjusts the fan speed
			according to room temperature.
COOL			Cooling only unit do not have displays and functions
			related with heating
DRY			In DRY mode, when room temperature becomes
			lower than temp.setting+2oC,unit will run intermittently
			at LOW speed regardless of FAN setting.
HEAT			In HEAT mode,warm air will blow out after a short
			periodof the time due to cold-draft prevention function.
			In FAN operation mode, the unit will not operate in
FAN			COOL or HEAT mode but only in FAN mode ,AUTO is
	nothing		not available in FAN mode.And temp.setting is disabled.
			When FAN is set to AUTO, the air conditioner automatically
			adjusts the fan speed according to room temperature.
			In FAN mode,SLEEP operation is not available.

Air Flow Direction Adjustment

1.Status display of air flow

Press button to enter additional options, when

cycle display to , will flash. And then press enter to up and down air flow function.

Press button. For each press,changes as follows: Remote controller:

COOL/DRY:

HEAT: Initial state

2.Left and right air flow adjustment

(This function is unavailable on some models.)

Press button to enter additional options, when

cycle display to , will flash. And then press enter to Left and right air flow function.

Press button. For each press,changes as follows: Remote controller:

COOL/DRY/HEAT:

Cautions:

When adjusting the flap by hand,turn off the unit.

When humidity is high,condensate water might occur at air outlet if all vertical louvers are adjusted to left or right.

It is advisable not to keep horizontal flap at downward position for a long time in COOLor DRY mode , otherwise, condensate water might occur.

Note:

When restart after remote turning off, the remote controller will automatically return to the previous set swing position.

Loading of the battery

1 Remove the battery cover;

2 Load the batteries as illustrated.

2 R-03 batteries, resetting key (cylinder);

3 Be sure that the loading

4 is in line with the" + "/"-";Load the battery,then put on the cover again.

Note:

The distance between the signal transmission head and the rece- iver hole should be within 7m without any obstacle as well.

When electronic-started type fluorescent lamp or change- over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals, so the distance to the indoor unit should be shorter.

Full display or unclear display during operation indicates the batteries have been used up. Please change batteries.

If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case won't be in use for a long period. If there is any display after taking-out, just press reset key.

2