Maintenance

Water inlet valve and inlet valve filter

To prevent blockage to the water supply by ingress of foreign

substances, clean the water inlet valve and inlet valve filter regularly.



Moving the machine

If the machine is to be moved to a distant loca

, replace the transportamoved before

installato prevent damage as shown below.

Remove the back cover.

Remove the blanking plugs.

Insert the synthe

and the transportabolts.

Tighten the bolts with a spanner.

Replace the back cover.

Long periods of disuse

If the washing machine is leor a long period, pu

ll out the electrical plug and turn off the water

supply. Open the washer door to prevent formaof

moisture and odors. Let the door open while

not used.

 

Display Codes

 

Display Codes and Special func



Codes

Err1

Err2

Err3

Err4

Err5

Causes

Door is not properly shut.

Drainage error, water not empwithin 6 minutes.

Temperature sensor not properly

connected or damaged.

Heater error (Appears at the end of a cycle).

Water level not met in 8 minutes.

The height of the drain hose is below 80 cm.

The drain hose is in water.

Solu

Shut the door properly, and then press the Start/Pause bun.

Clean the filter and check the drain hose for blockage. If error sists, please contact the maintenance personnel.

Contact the maintenance personnel.

Contact the maintenance personnel.

Make sure that tap is turned on, and water pressure is normal.

If problem s exists, please contact the maintenance personnel.

Install drain hose within 80-100 cm of height.

Make sure the drain hose is not in water.

18

Page 18
Image 18
Haier HW80-1279 user manual Maintenance, Display Codes