Trouble-Shoo
ng
ngTrouble-Sho
Problem | Causes | Solu ons |
Washing machine fails to operate.
Washing machine cannot be filled with water.
Machine is draining while being filled.
Drainage failure.
wash cycle.
Excessive foam in the drum, which is
Spinning fails
Power failure.
The washer door is not properly closed. Machine has not been switched on.
Water tap is not turned on.
Water pressure is less than 0,03 MPa. The inlet hose is kinked.
Water supply failure.
The program knob is not properly set. The washer door is not properly closed. The inlet hose filter is blocked.
The height of the drain hose is below 80 cm.
The drain hose is in water.
Drain hose is blocked.
Drain hose end is higher than 100 cm abovethe floor level.
The filter is blocked.
removed.
Washing machine is located on an uneven surfaceor is not level.
Machine load is over 8kg.
Water or electricity failure.
Washing machine gives an error message. Washing machine is in soaking cycle?
The detergent is not a
Excessive use of detergent.
adjusted
Unbalance of the laundry
Check the power supply.
Close the washer door properly.
Make sure the machine is switched on.
P
Turn on the water tap. Check water pressure. Check the inlet hose.
Ensure the water supply.
Set the program knob properly. Close the washer door properly. Unblock the inlet hose filter.
Install drain hose within
Make sure the drain hose is not in water.
Unblock the drain hose.
Make sure the drain hose end is lower than 100 cm above floor level. Unblock the filter.
Make sure the washing machine is on an even surface and levelled. Reduce amount of laundry in the drum.
Check the power supply or water supply.
Check display codes.
Check if your detergent is appropriate.
Reduce amount of detergent in the
This is normal and doesn't affect the
Add clothes or run a spinning program again.
20
