Panasonic KX-TG2650N Problem Remedy, Digits long, the number will not be, Redialed correctly

Before Requesting Help

	Problem			Remedy
The handset or base unit		•Do not pause for over 60 seconds while
display goes to the standby			searching.
mode while viewing the		•	,	or (DIGITAL!SP-PHONE).
Caller List.			was pressed.
When a second call is		•The line mode selection is incorrect. See
received during a			page 14.
conversation, the unit does
not display the new caller’s
name and/or phone number.
You cannot page the		•The handset is too far from the base unit.
handset or the base unit.		•The handset or the base unit is engaged
			in an outside call or is viewing the Caller
			List/directory list. Try again later. If you
			are using the base unit, wait until
			“Handset in use” disappears.
You cannot redial by		•If the last number dialed was more than
pressing (REDIAL/PAUSE) or			32 digits long, the number will not be
(REDIAL).			redialed correctly.
		•Access numbers entered after pressing
			(TONE) will not be included when
			redialing.
		•The (REDIAL/PAUSE) button on the
			handset has a double function as either
			redial or pause. It will redial the last
			number dialed if pressed at the outset of
			a call (p. 20). If another number has
			been dialed first, it will operate as a
			pause button (p. 49).
“Recharge battery” is		•Charge the battery fully (p. 11).
displayed on the handset,
“	” flashes or the unit

beeps intermittently.

You charged the battery fully, but “Recharge battery” is still displayed

and/or “ ” continues to flash.

•Clean the charge contacts and charge again (p. 12).

•Install a new battery (p. 58).

62