Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
If you do not need spraying spin, you can fill water into the wash tub directly through this entrance. It can reduce the humidity inside the control panel significantly and prolong the operating life of the components.
Quick
Water inlet hose
Water inlet jointer Push 
Control handle
Quick 
Install the lint filter
After opening the package,please take out the lint |
|
filter from the document bag,install it to the overflow |
|
filter of the wash tub.See to the figure. | Overflow filter |
Lint filter
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm , or the drainage willnot be smooth enough and cause incomplete drainage.
<10cm
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
4.If extra drain hose is needed , please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
If the extra hose is too long, cut it either at point A or B.
>
30mm
<1.5m
AB
4
