Trouble-shooting Answer to question
(If there’s breakdown, please pull off the power plug before checking)
The following phenomenon are not breakdowns sometimes. Please confirm again before sending it to repair.
If there are real breakdowns, please come to the special maintenance department or
Phenomena | The reason | How to settle | ||||
|
|
|
| |||
The digitron displays E0. | The top lid is open during | Close the top lid. | ||||
|
|
| reserve procedure. |
|
| |
|
|
|
| |||
The drainage cannot | Is the drain hose put down? | Put down the drain hose. Open and | ||||
work, or is too slow. The | Is the drain hose blocked? |
| close the top lid once. | |||
digitron displays E1. |
| | Clean the foreign material. Open and | |||
|
|
|
|
| close the top lid once. | |
|
|
|
| |||
|
|
|
| |||
It stops running in | The top lid is not closed. | Close the top lid. | ||||
midway. The digitron |
|
|
| |||
displays E2. |
|
|
|
| ||
|
|
|
| |||
The safety switch acts, | Are the laundries put slantingly? | Reorder the laundries. Close the top lid. | ||||
and the spinning cannot | Is the machine slanting? | Place the machine horizontally, open | ||||
work. The digitron |
|
| and close the top lid once. | |||
displays E3. |
|
|
|
| ||
|
|
|
| |||
The water filling does | Is the water tap opened, or is | Open the water tap. Open and close the | ||||
not work, or is slow, the | there water supply failure? |
| top lid once. | |||
digitron displays E4. | Is the water inlet valve blocked? | Clean the water inlet valve then open | ||||
|
|
| Is the water pressure too low? |
| and close the top lid once. | |
|
|
|
| |||
|
|
|
| Use after the water pressure is normal. | ||
|
|
|
| |||
The digitron displays E6. | The water level sensor is bad. | Please contact the | ||||
|
|
|
|
| department. | |
|
|
|
|
| ||
|
|
|
|
| ||
The |
| Not wash | Is there power failure? | Please use it when there’s power | ||
machine |
|
| Is the power plug inserted tightly? |
| supply. | |
does not |
|
| Is the water level reached preset | Insert the power plug tightly. | ||
| ||||||
act |
|
| position? | Fill water to the preset position. | ||
|
|
|
| |||
|
|
|
|
| ||
|
| Not spin | Is the power plug inserted tightly? | Insert the power plug tightly. | ||
|
|
| Is the top lid closed reliably? | Close the top lid. | ||
|
|
| Are the laundries set flat? | Set the laundries flat. | ||
|
|
|
|
|
| |
There is abnormal sound | Is the machine slanting? | Adjust the machine to be even | ||||
Are the laundries put slantingly in | ||||||
inside the machine | Reorder the laundries and close the top | |||||
spinning? | ||||||
|
|
|
| lid. | ||
|
|
| Are there any foreign materials? |
| ||
|
|
| Remove the foreign materials. | |||
|
|
| ||||
The water tap leaks | Is the screw of the jointer of water | Fasten the screw of the jointer properly. | ||||
|
|
| inlet hose loose or awry? |
|
| |
|
|
|
|
|
|
15