Haier HWM8000 user manual Common phenomena, Phenomena Explanation

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

Phenomenon		Reason	How to solve
It rings after starting the Reserve		The top lid is opened.	Close the top lid.
function. The digitron displays E0.
The drainage cannot work, or is too slow.		Is the drain hose blocked?	Clean the foreign material. Push
The digitron displays E1 and it rings.			the start button again.
After washing and rinsing, it stops
running during spinning. The		The top lid is not closed.	Close the top lid.
digitron displays E2 and it rings.
The safety switch acts, and the		Are the laundries put slantingly?	Reorder the laundries. Close the top lid.
spinning cannot work (after twice
			Set the washing machine horizontally and
		Is the machine slanting?
automatic imbalance revising). The
			then open and close the top lid once.
digitron displays E3 and it rings.
The water inlet does not work, or is		Is the water faucet opened, or is there	Open the water faucet. Push the
too slow (cannot reach the water			Start/Pause button again.
level after about 15 minutes). The		water supply failure?	Clean the water inlet valve then push the
digitron displays E4 and it rings.		Is the water inlet valve blocked?	Start/Pause button again.
The water temperature is too high.		The temperature is higher	After cooling. Press the Star/Pause knob.
The digital tube displays E5, and rings.		than 75 C.
The cascade current is poor or		Is there foreign material blocking	Clear the foreign material.
there's no cascade current.		the spray outlet?
		Is there power failure?	Please use it when there's power supply.
The machine	Not wash	Is the power plug inserted tightly?	Insert the power plug tightly.
		Is the water level reached preset	Fill water to the preset position.
does not act.		position?
	Not spin	Is the power plug inserted tightly?	Insert the power plug tightly.
		Is the top lid closed reliably?	Close the top lid.
		Are the laundries set flat?	Set the laundries flat.
		Is the machine slanting?	Adjust the machine to be even
There's abnormal sound inside		Are there any foreign materials?	Remove the foreign materials.
the machine		Are the laundries put slantingly in
			Reorder the laundries and close the top lid.
		spinning?
The water faucet leaks water		Is the screw of the water inlet hose	Fasten the screw of the jointer properly.
		jointer loose?
		Is the screw of the water inlet hose
		jointer twisted awry?
		Is the power plug plugged tightly?	Plug the power plug tightly.
No water inlet.		Is the water faucet opened?	Open the water faucet.
		Are the POWER ON/OFF and	Push the power ON/OFF button and
		START/PAUSE buttons pushed down?	START/PAUSE button.
Common phenomena

Phenomena	Explanation
The spinning is intermittent when it starts.	It is to balance the laundries to avoid slanting.
The wash procedure pauses.	The cloth sensor is detecting the cloth. It will start
	adding water after about 48 seconds.
Push the SPIN button, but it doesn't act.	The program is setting the drain time. A certain
	period is needed before it starts spinning.
The pulsator pauses during water filling in washing and rinsing.	It is to avoid splashing during water filling.
There may be some water flowing out of the drain	It is the water remained in the machine during the
hose in the first use of the machine.	ex-factory performance inspection.
In adding water, the pulsator performs stirring slightly	It is to soak the laundries more completely.

15