Inner tub Lint filter
After opening the package, please take out the lint
filter from the document bag, install it to the filter cover
of inner tub. See to the figure.
Install the lint filter
How to change the direction of the drain hose
1.The heightof the drain hose shall be
less than 10cm, or the drainage willnot
be smooth, and costsuch long time that
the machine may stop at midway.
2.Do not ramp or press the drainhose.
3.If the drain hose is too long,cut it at mid
point. To make smoothdrainage, cut the
frontend of the hose slantingly.
4.If extra drainhose is needed, please
make separate purchase.The inner
diameter of the extra hose shall not
less than 30mm, and the lengthshall
notexceed 1.5m.
Usage of the drain hose
The drain hose shall drain smoothly
1.Dismount the back cover of the washing machine.
2.Lay down the washing machine gently with the front
side facing the ground. Use cross screwdriver to
loosen the eight screws. Take off the bottom plate.
4.Dismount the protecting cover of the drain outlet at the
other side as indicated in Figure 3.
5.Extend the drain hose out of the other side. Fix the drain
hose onto the cabinet with the drain hose rack. Set the
drain hose nut on, and fasten the nut to the direction
indicated in the figure, as per Figure 4.
6.Install the protecting cover of the drain outlet to the other
side, as indicated in Figure 5.
7.Install the bottom plate (method the same as stated
above). Lift up the washing
machine gently.
3.Put down the outer drain hose.Twist the drain hose nut
counterclockwise to take it off as indicated in Figure 1.
Take off the drain hose rack. Put the drain hose into
the cabinet as indicated in Figure 2.
back
front
bottom plate
Page 4
drain outlet
protecting
cover
fasten
drain hose nut
Drain hose nut Drain hose rack
Outer
drain hose
Loosen
soft item
Figure 1
Figure 3 Figure 4
Figure 5
Figure 2
f the extra hose is too long, cut it either
at point A or B.
5