Cleaning the overflow filter

2.Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1).

3.Cleaning the overflow filter Clean the lint around the filter and flush with tap water.

4.Install the overflow filter.

(1).Install the corrugation pipe.

(2).Insert the mounting plate at the bottom of the filter into the valve cover.

(3).Hang up the hook at the left

upper side.

(4).Push the upper part in as indicated in Figure 2.

Water level adjusting lever

Corrugation

Pipe

Figure 1

Hook

Figure 2

Clean the safeguard cover

The safeguard cover must be used during washing.

The surface must be cleaned every time after washing.

The underside of the cover must be cleaned every

period of time.

Groove

1. Take off the safeguard cover

Use the thumb to fasten the indicated groove then take it out as the direction of the figure.

2.Clean the underside of the cover

Use the nipper or other spindly clamps to take out the lint , sundries etc.

3.Install the safeguard cover

After finish cleaning , fasten the safeguard cover to the tub bottom, infirm the claw install correctly and hard to fall off.