English

INSTALLATION INSTRUCTIONS

Risk of Fire:

1.Clothes dryer installation must be performed by a qualified installer.

2.Install the clothes dryer according to the manufacturer’s instructions and local codes.

3.To reduce the risk of severe injury or death, follow all installation instructions.

SAVE THESE INSTRUCTIONS

Tools and materials required

Phillips-Head and flathead screwdrivers

Channel-lock adjustable pilers

1/2-inch open-end wrench

Carpenter’s level

Measuring tape (12ft. min.)

Duct tape

Pipe thread sealer (Gas)

Rigid or flexible metal 4 inch (102cm) duct

Vent hood

Safety Warning:

1.Before starting installation, make sure that the gas shut off valve is in the off position.

2.All old gas connectors and gas piping should be discarded.

ELECTRICAL REQUIREMENTS

Electric Dryer: (RDE350AW)

Circuit

Individual 30 Amp branch circuit fused with 30 Amp time-delay fuses or circuit breakers. Use seperately fused circuits for washers and dryers, and DO NOT operate a washer and dryer on the same circuit.

Power Supply

3 or 4 wire, 240 Volt, 1 Phase, 60Hz, AC (Canada - 240 Volt, 1 Phase, 60 Hz, AC)

Power Supply Cord Kit

(Not supplied when sold in US. Must be purchased to meet local electrical codes.) The dryer MUST employ a 3-conductor power supply cord NEMA

10-30 Type SRDT rated at 240 Volt AC minimum, 30 Amp, with 3 open end

5

Page 6
Image 6
Haier RDE/RDG 350AW user manual Installation Instructions, Tools and materials required, Electric Dryer RDE350AW