Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Voltage change
This washer is assembled for 220V, but can be changed from 220V to 127V. Check your electrical source and follow the diagram below to convert voltage.
Green
Blue
White
(1). Please first pull off the power plug and hang up the power cord.
(2). Loosen the fastening screw and take off the back cover.
(3). Unknit the safeguard bag to expose the connectors.
(4). Detach the white connector from the green one(220V), then inlay it into the blue one(127V).
(5). Pack all the connectors with the safeguard bag as usual and fix it. Then install the back cover.
Above all the steps must be done by the special serviceman.
If you do not need spraying spin, you can fill water into the wash tub directly through this entrance. It can reduce the humidity inside the control panel significantly and prolong the operating life of the components.
Quick
Water inlet hose
Push |
|
| Water inlet jointer |
|
|
| |
Control handle |
| Quick | |
| |||
| |||
|
|
| |
Install the lint filter
After opening the package,please take out the lint |
|
filter from the document bag,install it to the overflow |
|
filter of the wash tub.See to the figure. | Overflow filter |
Lint filter
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm , or the drainage willnot be smooth enough and cause incomplete drainage.
<10cm
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
4
