Installation and adjustment

Before Using

Please install and adjust the machine according to the requirement of the mannual.

It is very important to your security and correct operating the machine.

Install the inner cover and lint filter

1.Open the top lid of the washing machine.

2.Put the inner cover component on the outer tub cover, aiming

Outer tube cover

the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove.

3.Firstly insert the inner cover shaft of one side into the correspon -ding outer tub cover shaft groove, then push the another inner cover shaft into the corresponding outer tub cover shaft groove. Please install to designated position to guarantee there are no dropping or abnormal sound in opening and closing of the inner cover, and the operation shall be smooth. Do not dismount the inner cover component after washing.

4.Install the lint filter in the balance ring.(See to the right figure)

Install the bottom plate

After opening the package, please lean the washing machine gently down on soft items (like towel cloth, blanket, etc.). Installthe bottom plate to the bottom of the machine with eight screws by a cross screwdriver, then lift the machine up gently. (See to the figure)

Inner cover shaft

Inner cover

Install the lint filter

Back

Front

bottom plate

Soft object

Screw

Adjust the Installation position

The washing machine away from wall should be overrun 20mm.The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:

Confirm it's horizontal:

Hang the lead line to check if it is horizontal.

Adjust the adjustable leg:

1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.

2 . After adjustment, fasten the nut.

the adjustable nut

Loosen Fasten

High

Low

the adjustable foot

Page 5
Image 5
Haier WM6002A Install the inner cover and lint filter, Install the bottom plate, Adjust the Installation position