Haier WM6002A Trouble-shooting Answer to question, Phenomenan, The reason, How to settle

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

Phenomenan			The reason	How to settle
The digitron displays E0.		The top lid is opened during reserve		Close the top lid.
		procedure.
The drainage cannot work, or is too slow.		Is the drain hose put down?		Put down the drain hose. Open and close the
The digitron displays E1.		Is the drain hose blocked?		top lid once.
				Clean the foreign material. Open and close
				The top Lid Once.
It stops running in midway. The digitron		The top lid is not closed.		Close the top lid.
displays E2.
The safety switch acts, and the		Are the laundries put slantingly?		Reorder the laundries. Close the top lid.
spinning cannot work. The		Is the machine slanting?		The machine will start running after 10
digitron displays E3.				seconds of being placed horizontally.
The water filling does not work, or is		Is the water tap opened, or is there water		Open the water tap. Push the start/Pause
slow. After about 15 minutes later,		supply failure?		button once.
the digital displays E4.		Is the water inlet valve blocked?		Clean the water inlet valve then push
				the start/Pausebutton once.
		Is the water pressure too low?
				Push the Start/Pause button once.
The digitron displays E6.		The water level sensor is bad.		Please contact the after-sales
				service department.
The digitron displays E8.		The power voltage is too low.		Pull off the power plug. Wait for the
The digitron displays E9.		The power voltage is too high.		voltage resuming normal before usage.
		Is there power failure?		Please use it when there's power supply.
	Not wash	Is the power plug inserted tightly?		Insert the power plug tightly.
The machine does		Is the water level reached preset position?		Fill water to the preset position.
not act		Is the power plug inserted tightly?		Insert the power plug tightly.
	Not spin	Is the top lid closed reliably?		Close the top lid.
		Are the laundries set flat?		Set the laundries flat.
There's abnormal sound		Is the machine slanting?		Adjust the machine to be level
		Are the laundries put slantingly in spinning?		Reorder the laundries and close the top lid.
inside the machine
		Are there any foreign materials?		Remove the foreign materials.
The water tap leaks		Is the screw of the jointer of water		Fasten the screw of the jointer properly.
		inlet hose loose or awry?
Common phenomena
Phenomena			Explanation
* The spinning is intermittent when it starts.			* Balance the laundries to avoid slanting.
* The wash procedure pauses.			* The cloth sensor is detecting the cloth. It will start
			adding water after about 48 seconds.
* Select “ SPIN” program, but it doesn’t work.			* The program is setting the drain time. A certain
			period is needed before it starts spinning.
* The pusaltor pauses during washing, rinsing			* It is to avoid splashing during water filling.
or adding water.
* There may be some water flowing out of the			* It is the water remained	in the performance
drain hose in the first use of the machine.			inspection by the factory.