Haier XQG50-S1016 operation manual Trouble shooting, Door and then close the porthole. Do not shut

Matters needing attention

8.The washing machine must not be used in	9. The washing machine should be placed
the open or in an area of high humidity as	in a well-ventilated area, leaving a space
water droplets may form on the electrical	between the appliance and adjacent walls or
components. Air dry the appliance if the	furniture.
washing machine components become wet.

10. Keep away from heat sources and direct	11. During installation, ensure that the
sunlight to prevent plastic and rubber com-	electric cable is not trapped by the washing
ponents from ageing.	machine and damaged.
	Dear customer, For the machine and your
	own security, DO NOTREPAIR IT BY YOUR-
	SELF! DO NOT USE THE WASHING MA-
	CHINE WHICH SOME PARTS ARE LOST!

Use

1. Make sure that the washing machine is	2. Fasten the door handle before opening the
securely connected to the water supply. Take	door and then close the porthole. Do not shut
the necessary precautions or contact the lo-	the door violently.
cal service centre if the connection is poor or
there is a water leak.

Trouble shooting

The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed.

problem	Possible Cause
	Poor connection to power supply
The washing machine fails to	Power failure
	Door is not closed properly
operate
	Machine has not been switched on
	Water is not turned on
	Water pressure is less than 0.05MPa
The washing machine does not	The inlet hose has a kink
fill with water	Water supply failure
	The door is not closed properly
The water supply and drainage	Check that the height of the water hose is within 80-100cm
do not stop	Check that the drain hose is not syphoning
Drainage failure	Drainage hose is blocked
	Drainage hose end is more than 100cm above the floor
	level
	Check that all packing bolts have been removed
Strong vibration during spin	The washing machine is located on an uneven surface of
	is not level
drying
	Check that all foam packing has been removed from the
	motor
Operation stops before com-	Water of electricity failure
pletion of the wash cycle
Excessive foam in the drum	The detergent is not a low foam type
	Excessive detergent has been used
	Poor connection to the power source
Failure of the drying process	Door is not closed properly
	Program has not been correctly set
	Check to see if the end of the water drainage hose is
	submerged in water
Incomplete drying	The filter is blocked
	The machine is overloaded
	The water tap is not tured on

2 15