Hama RDR-HX900 Step 5: Connecting the Mains Lead, Step 6: Preparing the Remote, you must wait for a short while before operating the recorder

Step 5: Connecting the Mains Lead

Connect the supplied mains lead to the AC IN terminal of the recorder. Then plug the recorder and TV mains leads (power cords) into the mains. After you connect the mains lead, you must wait for a short while before operating the recorder. You can operate the recorder once the front panel display lights up and the recorder enters standby mode.

If you connect additional equipment to this recorder (page 26), be sure to connect the mains lead after all connections are complete.

Step 6: Preparing the Remote

You can control the recorder using the supplied remote. Insert two R6 (size AA) batteries by matching the 3 and # ends on the batteries to the markings inside the battery compartment. When using the remote, point it at the remote sensor on the recorder.

Settings and Hookups

1 to AC IN

2

to mains

Notes

•If the supplied remote interferes your other Sony DVD recorder or player, change the command mode number for this recorder (page 21).

•Use the batteries correctly to avoid possible leakage and corrosion. Do not touch the liquid with bare hands should leakage occur. Observe the following:

–Do not use a new battery with an old battery, or batteries of different manufacturers.

–Do not attempt to recharge the batteries.

–If you do not intend to use the remote for an extended period of time, remove the batteries.

–If battery leakage occurs, wipe out any liquid inside the battery compartment, and insert new batteries.

•Do not expose the remote sensor (marked on the front panel) to strong light, such as direct sunlight or

lighting apparatus. The recorder may not respond to the remote.

,continued 19