840115700 Ev00.qxd 6/6/03 8:59 AM Page 15
The Filler Cap Is Difficult to Remove
• Sometimes a vacuum can form in | • Apply 100% pure petroleum jelly | |
| the tank, | to the filler cap gasket. Wipe off |
| especially | any excess. |
| if it has not |
|
| been seated |
|
| on the base |
|
| for a long |
|
| period of |
|
Press here | time. Press |
|
| the button |
|
| in the center |
|
of the filler cap to relieve the vacuum.
Fan Enclosure or Tank Does Not Fit on Base
•Make sure that the cord or other objects are
not trapped under the fan enclosure or tank.
•New filters are shipped flat and must be “rounded” before installation. Gently pull the filter into a round shape, being careful not to tear it. Once the filter is properly rounded, install it and lower the fan enclosure into place (as described on page 6).
• Is the cord routed correctly? The
| cord should | New filter | Rounded filter |
| be pressed | ||
Cord |
|
| |
completely |
|
| |
behind | into the cord |
|
|
tabs |
|
| |
exit notch. |
|
| |
|
|
| |
| Any excess |
|
|
Cord | cord should |
|
|
exit | be completely |
|
|
notch | behind the |
|
|
|
|
| |
| tabs in the |
|
|
cord storage compartment, as |
|
| |
shown above. |
|
|
|
15