Manuals / Hamilton Electronics / Kitchen Appliance / Convection Oven

Hamilton Electronics 8534-01 manual Operation, Installing the software

Models: 8534-01

1 33

Download 33 pages 26.78 Kb

Page 15

Operation

MICROLAB® Carousel User Guide (June 2003)

Operation

Installing the software

After your MICROLAB® Carousel hardware is installed, you can install the

Hamilton MICROLAB® Carousel Software.

Your MICROLAB® Carousel software comes with an installation wizard that guides you through the installation as it copies the program files to your computer.

Before you begin the installation, make sure that you have closed any open applications on your PC. Carousel software requires Windows 2000 (with service pack 2 or higher) or Windows XP Professional, and 128 MB RAM (minimum).

If installing SWAP software also, and SWAP version is 2.0 or less, SWAP software must be installed first.

To install MICROLAB® Carousel software:

1.Place the CD labeled “Hamilton MICROLAB® Carousel Software” into the CD drive on your PC.

2.The install program should run automatically. If it does not, select Start > Run > (the CD-ROM drive identifier on your PC) \ Setup.exe. Click the OK button when the prompt appears.

The InstallShield Wizard starts when the Welcome to the InstallShield Wizard for Carousel window appears (figure 12).

Figure 12: Welcome window

13

Image 15

Hamilton Electronics 8534-01 manual Operation, Installing the software

Contents

MICROLAB Carousel User GuidePart Number 8534-01Rev. A June MICROLAB Carousel User Guide June ContentsAbout this guide About the MICROLAB CarouselFigure 1 Carousel accessory There are four symbols used in this guide Safety precautionsFCC compliance Carousel components Figure 3 Carousel housing assemblyFigure 2 Platter sizes Carousel housing assembly Setting up the carousel3.Secure the carousel base plate brackets 7918-01to the left and right sides of the housing assembly, in the desired position 1, 2, or 3, with the washer and screw shown in figure Index bracket platter kit DIP switch setting DESCRIPTION PLATTER SELECTDESCRIPTION UNIT IDENTIFICATIONFigure 9 Plug orientation Connecting cablesCarousel platter Figure 11 Mounting feet locations MICROLAB Carousel User Guide JuneOperation Installing the software6.Type the name of your lab and click Next Calibration Figure 15 Calibration alignment Carousel service software Writing a method Figure 17 Instruments window Carousel commands InitializeMove To Position Using the serial interface Installing landscape stackers Installing portrait stackers and shelvesMICROLAB Carousel User Guide June Figure 22 Location of numbered position lineFigure 23 Landscape stackers General MaintenanceCorrective action TroubleshootingError code Possible causeSpecification SpecificationsCarousel Indoor Operation and Use OnlyMICROLAB Carousel User Guide June Manuals CableShelves and stackers SoftwareIn Switzerland Contacting Hamilton CompanyIn the United States and Canada Outside the U.S. and CanadaMICROLAB Carousel User Guide June MICROLAB Carousel User Guide Part No. 8534-01Rev. A