Bottom Panel Features

I/O Connector

Hand Strap Slot

Hand Strap Slot

There is an adjustable, elastic hand strap available for purchase with the Dolphin 7600 terminal. When installing the hand strap, you loop the elastic strip through this slot. For instructions, see Attaching the Hand Strap on page 3-15.

I/O Connector

The I/O mechanical connector is designed to work exclusively with Dolphin 7600 peripherals and cables. This connector powers the terminal, charges the main battery, and facilitates communication. This connector supports full speed USB 1.1 communication (up to 12 Mbps) and RS-232 communications with a maximum speed of 115Kbps and seven baud rate settings.

Through this connector, you can communicate with a host workstation via Microsoft ActiveSync; see ActiveSync Communication on page 6-3.

The I/O connector supports the following signals:

Data Carrier Detect

Received Data

Transmitted Data

Data Terminal Ready

Signal GND

Data Set Ready

Request To Send

Clear To Send

Ring Indicator

USB GND

USB +5V

USB D+

USB D-

Note: Signals referenced are for a DTE device.

3 - 14

Rev D

Dolphin® 7600 User’s Guide

 

10/18/2007

 

Page 30
Image 30
Hand Held Products 7600 manual Bottom Panel Features, Hand Strap Slot, Connector