Technical Information
Recommended water pressure | 14.7 - 72.5 psi | |
Hole size in mounting surface | 1 | 3/16" |
Max. wall thickness | 1 | 1/2" |
Flow rate | .2 gpm | |
This faucet is intended for cold water only. |
|
|
Installation Considerations
•For best results, Hansgrohe recommends that this unit be installed by a licensed, profes- sional plumber.
•Please read over these instructions thoroughly before beginning installation. Make sure that you have all tools and supplies needed to complete the installation.
•This faucet requires a 1/2" NPT male nipple, extending 1/2" outside the surface of the
finished wall.
• Stud supports for the mounting flange must be installed.
• Extreme care should be taken to avoid dam- age to hidden electrical or plumbing lines when drilling the screw holes.
• Do not use petroleum based plumbers putty. If desired, seal around the flange with silicone sealant.
Installation
Wrap the threads on the nipple with Teflon tape.
Install the mounting flange. It should be centered over the nipple.
Caution: while drilling the screw holes, use extreme caution not to damage hidden electrical or plumbing lines.