Fujitsu 5000 Installing internal options to 3.5-inch expansion bays, Set the internal option

■Installing internal options to 3.5-inch expansion bays

This section explains how to install 3.5-inch expansion bay options such as a 3.5-inch internal hard disk, magneto-optic disk drive, and 3.5-inch floppy disk drive. A magneto-optic disk drive is used below in an installation example.

1

2

Set the internal option.

See the manual accompanying the internal options to set the following items.

-To install an IDE-standard internal option: Set the master, slave, and cable selection.

-To install a SCSI interface internal option: Set the SCSI ID.

If retaining metal brackets are mounted on

both sides of the internal hard disk to be

installed, remove them.

Remove the screws (four) to remove the retaining metal brackets.

OFF

P

Q

R

S

T

U

V

W

3

4

Remove the upper cover.

Remove the front panel.

The front panel does not need to be removed when installing a hard disk.

5 Remove the blank panel.

Remove the screw (one) to remove the blank panel.

The blank panel does not need to be removed when installing a hard disk.

37