Fujitsu 5000 Replacing a internal hard disk equipped as standard, Set up the jumper switch

■Replacing a internal hard disk equipped as standard

This section explains how to replace a standard-equipped internal hard disk with a hard disk of larger capacity.

1

2

Set up the jumper switch.

See the manual accompanying the internal hard disk and make sure that the jumper switch has been set to master, or cable select.

If retaining metal brackets are mounted on

both sides of the internal hard disk to be

replaced, remove them.

Remove the screws (4) to remove the retaining metal brackets.

3

4

5

Remove the upper cover.

Disconnect the hard disk cables.

Disconnect the power cord and flat cables connected to the hard disk.

Remove the retaining metal bracket.

Remove the screw (one), then remove the retaining metal bracket by sliding it in the direction of arrow 1 , then arrow 2 , and then lift it in the direction of arrow 3 .

3

1

2

35