Hans Grohe 15181XX1 Pull the faucet housing off, Cleaning Block the sensor for 5 seconds

Models: 15181XX1 15180XX1

1 12

Page 5

Use a screwdriver to set the water temperature (2). Turn the screw to the rear to make the water warmer, to the front to make it cooler.

This will turn the water off for approximately 75 seconds so that the sink may be cleaned (2).

Image 5

Contents

15180XX1 Electronic15181XX1 Installation Instructions / WarrantyCaution do not bend or twist the supply hoses Technical dataHansgrohe Electronic Lavatory Faucet with Temperature Control Hansgrohe Electronic Lavatory FaucetInstall the adapters on the stops InstallationInstall the filters 4 and supply lines Place the faucet in the hole in the mounting surfacePeel the protective film from the sensor Turn the water on to the faucetModel 15181 only Turn the water off at the stops Remove the set screw on the back of the faucetCleaning Block the sensor for 5 seconds Pull the faucet housing offReplace the faucet housing. Tighten the set screw Reset the faucet Remove the set screw with a 2.5 mm Allen wrench Faucet MaintenanceBlock the sensor for 2 seconds Wait 10 seconds 1, then replace the set screwCleaning the filters and aerator To clean the filters Turn the water off at the stops Replacement Parts Cleaning Procedures Cleaning Recommendation for Hansgrohe ProductsCleaning Materials for Faucets and Showers WHO IS COVERED BY THE WARRANTY Limited Lifetime Consumer WarrantyWHAT IS COVERED BY THE WARRANTY LENGTH OF WARRANTYPRODUCT INSTRUCTIONS AND QUESTIONS TO OBTAIN WARRANTY PARTS OR INFORMATIONEXCLUSIONS AND LIMITATIONS