Hans Grohe 15180XX1, 15181XX1 To clean the filters Turn the water off at the stops

Models: 15181XX1 15180XX1

1 12

Page 8

Disconnect the supply hoses from the adapters (2). Pull the filters out and clean them.

Image 8

Contents

Electronic 15180XX115181XX1 Installation Instructions / WarrantyTechnical data Caution do not bend or twist the supply hosesHansgrohe Electronic Lavatory Faucet with Temperature Control Hansgrohe Electronic Lavatory FaucetInstallation Install the adapters on the stopsInstall the filters 4 and supply lines Place the faucet in the hole in the mounting surfaceTurn the water on to the faucet Peel the protective film from the sensorModel 15181 only Turn the water off at the stops Remove the set screw on the back of the faucetCleaning Block the sensor for 5 seconds Pull the faucet housing offReplace the faucet housing. Tighten the set screw Faucet Maintenance Reset the faucet Remove the set screw with a 2.5 mm Allen wrenchBlock the sensor for 2 seconds Wait 10 seconds 1, then replace the set screwCleaning the filters and aerator To clean the filters Turn the water off at the stops Replacement Parts Cleaning Procedures Cleaning Recommendation for Hansgrohe ProductsCleaning Materials for Faucets and Showers Limited Lifetime Consumer Warranty WHO IS COVERED BY THE WARRANTYWHAT IS COVERED BY THE WARRANTY LENGTH OF WARRANTYPRODUCT INSTRUCTIONS AND QUESTIONS TO OBTAIN WARRANTY PARTS OR INFORMATIONEXCLUSIONS AND LIMITATIONS