Hans Grohe 15181XX1, 15180XX1 installation instructions Cleaning the filters and aerator

Models: 15181XX1 15180XX1

1 12

Page 7

Wait 15 seconds (3), then place a hand in front of the sensor (4). The water should turn on.

If the flow of water is reduced, the filters and/or the aera- tor must be cleaned.

To clean the aerator: Block the sensor for 5 seconds to temporarily shut off the water (1).

Unscrew and remove the aerator. Flush any debris from the aerator at another faucet (2).

Image 7

Contents

Installation Instructions / Warranty Electronic15180XX1 15181XX1Hansgrohe Electronic Lavatory Faucet Technical dataCaution do not bend or twist the supply hoses Hansgrohe Electronic Lavatory Faucet with Temperature ControlPlace the faucet in the hole in the mounting surface InstallationInstall the adapters on the stops Install the filters 4 and supply linesRemove the set screw on the back of the faucet Turn the water on to the faucetPeel the protective film from the sensor Model 15181 only Turn the water off at the stopsReplace the faucet housing. Tighten the set screw Pull the faucet housing offCleaning Block the sensor for 5 seconds Wait 10 seconds 1, then replace the set screw Faucet MaintenanceReset the faucet Remove the set screw with a 2.5 mm Allen wrench Block the sensor for 2 secondsCleaning the filters and aerator To clean the filters Turn the water off at the stops Replacement Parts Cleaning Materials for Faucets and Showers Cleaning Recommendation for Hansgrohe ProductsCleaning Procedures LENGTH OF WARRANTY Limited Lifetime Consumer WarrantyWHO IS COVERED BY THE WARRANTY WHAT IS COVERED BY THE WARRANTYEXCLUSIONS AND LIMITATIONS TO OBTAIN WARRANTY PARTS OR INFORMATIONPRODUCT INSTRUCTIONS AND QUESTIONS