Hans Grohe 15180XX1, 15181XX1 Faucet Maintenance, Block the sensor for 2 seconds

Models: 15181XX1 15180XX1

1 12

Page 6

Image 6

Contents

15181XX1 Electronic15180XX1 Installation Instructions / WarrantyHansgrohe Electronic Lavatory Faucet with Temperature Control Technical dataCaution do not bend or twist the supply hoses Hansgrohe Electronic Lavatory FaucetInstall the filters 4 and supply lines InstallationInstall the adapters on the stops Place the faucet in the hole in the mounting surfaceModel 15181 only Turn the water off at the stops Turn the water on to the faucetPeel the protective film from the sensor Remove the set screw on the back of the faucetPull the faucet housing off Replace the faucet housing. Tighten the set screwCleaning Block the sensor for 5 seconds Block the sensor for 2 seconds Faucet MaintenanceReset the faucet Remove the set screw with a 2.5 mm Allen wrench Wait 10 seconds 1, then replace the set screwCleaning the filters and aerator To clean the filters Turn the water off at the stops Replacement Parts Cleaning Recommendation for Hansgrohe Products Cleaning Materials for Faucets and ShowersCleaning Procedures WHAT IS COVERED BY THE WARRANTY Limited Lifetime Consumer WarrantyWHO IS COVERED BY THE WARRANTY LENGTH OF WARRANTYTO OBTAIN WARRANTY PARTS OR INFORMATION EXCLUSIONS AND LIMITATIONSPRODUCT INSTRUCTIONS AND QUESTIONS