Page 5SKU 03664 For technical questions, please call 1-800-444-3353.
UnpackingWhen unpacking, check to make sure the following parts are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Assembly1. Insert the Torch Cable (connection end) into the cable strain relief on the end of the
unit. Refer to the photos on the next page.
2. Loosen and unlock the Wire Tension Control.
Wire Spool (1) not shown
Torch Cable and Handle (2)
MIG 200 Amp Welder
220 VAC Power Cord
Ground Cable and Clamp (3)
3. Avoid eye and body damage. Arc ra ys and infrared radiation can injure e yes and b urn
skin. Wear ANSI approved arc shaded, impact safety full f ace shield and body protection.
Do not allow viewing by visitors without proper eye and body protection.
4. Know proper arc welding practices. Read and understand the manufacturer’s
instructions, and well as your employer’s safety practices for arc welding.
5. Connect only to a code approved power source. Connect only to a grounding power
source conforming to the National Electrical Code and Local Codes.
6. Avoid fire and explosion. Remove flammable and explosive material from at least 35
feet from the welding arc to prevent welding sparks or molten metal from starting a fire.
Keep a type ABC fire extinguisher within easy reach. Thoroughly clean the object being
welded of any paint, grease, or other foreign material.
7. Avoid being burned. Always wear ANSI appro ved welding gear: leather gloves, leather
apron, and shoes.