Wire Tension 
Control and Lock
Bracket “A”
Current Collector (with Wire Routing Housing)
Feed Control
Wheel
Wire Routing
Housing
Cable Strain Relief
Square
Connector “C”
Gas Tube
Outlet “B”
Receptacle “D”
3.Attach the Current Collector (with Wire Routing Housing) to Bracket “A” and tighten. Refer to photos above.
4.Press the white Gas Tube onto the black outlet “B”.
5.Plug the white tube Square Connector “C” into the matching receptacle “D”.
6.Wind (or place) the welding wire onto the Wire Spool (not shown), and mount the Wire Spool onto the Wire Feed Axis Mechanism. See photo on next page.
7.Guide the welding wire into the Wire Routing Housing until it passes the Feed Control Wheel, and into the Torch Cable.
8.Connect a 220 VAC plug (not supplied) to the line cord. This step must be done by a licensed electrician.
9.Plug the line cord into a 220 VAC electrical outlet.
10.Flip the Power Switch on the front of the unit to the ON (I) position. The blower will start.
SKU 03664 | For technical questions, please call | Page 6 |
