Fence Use and Installation

Step 1: The FENCE (#65) can only be used when edge of stock is flat and at a 90° angle to the surface being plane.

Step 2: The Fence must be used to engage is Rabbeting Procedures (see below).

Step 3: To install the FENCE, first loosen the front KNOB (#61) by turning it counterclockwise. (See Figure 2.)

Knob (#61)

Fence

(#65)

Figure 2 — Using the Fence

Step 4: Insert the fence into the hole as shown in Figure 2.

Step 5: Though the FENCE is shown being installed in the right side, it can be positioned on the left as well.

Step 6: Set the fence so that it rests against the edge of the stock and so that the cutterhead is positioned to plane the desired area.

Step 7: Tighten the KNOB by turning clockwise.

Page 7 -- SKU: 32222

Page 7
Image 7
Harbor Freight Tools 32222 operating instructions Fence Use and Installation, Knob #61 Fence #65, Sku