Cleaning, Maintenance, and

Lubrication

1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, loose or worn out blade, and any other condition that may affect its safe operation.

2.After Use, clean external surfaces of the tool with clean cloth. Drain wa- ter from the water tray and wash out any residue from the recessed pump sump area.

3.Tool service must be performed only by qualified repair personnel.

Service or maintenance performed by unqualified personnel could result in a risk of injury.

4.When servicing a tool, use only identical replacement parts. Fol- low instructions in the “Inspec- tion, Maintenance, And Cleaning”

section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.

5.WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.

6.To clean: Wipe with a damp cloth, vacuum or use compressed air. Do not use solvents.

7.When storing: Store Tile Saw in a safe, clean, dry, location out of reach of children.

8.CAUTION! All maintenance, service, or repairs not listed in this manual are only to be attempted by a qualified service technician.

Troubleshooting

Problem

 

Possible Causes

 

Likely Solutions

Tool will not start

1.

No power at outlet.

1.

Check power at outlet.

2.

Cord not connected.

2.

Check that cord is plugged in.

 

Blade spins slowly

1.

Arbor shaft binding

1.

Check shaft for free spinning

2.

Motor brushes worn

2.

Replace brushes

Excessive vibration

1.

Bent or off-balance blade

1.

Replace blade with new one

 

2.

Bent Arbor Shaft

2.

Check shaft for run-out

Running hot;

1.

Water flow problem.

1.

Check connection

excess smoke

2.

Not enough water

2.

Add proper amount of water

 

3.

Running with hot/warm water

3.

Always run with cold water

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.

SKU 3733

For technical questions, please call 1-800-444-3353.

Page 17

Page 17
Image 17
Harbor Freight Tools 3733 Cleaning, Maintenance, Lubrication, Troubleshooting, Problem Possible Causes Likely Solutions