POWER
CORD
TILE SAW
120VOLT,
GROUNDED ELECTRICAL OUTLET
DRIP LOOP
Figure 1
13.Always arrange a “drip loop” in the Power Cord (11) connecting the Tile Saw to a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power Cord below the level of the outlet, or the connector
if an extension cord is used, to pre- vent water traveling along the Power Cord and coming in contact with the outlet. If the Power Plug or electrical outlet does get wet, do not unplug the Power Cord. Disconnect the fuse or circuit breaker that supplies power to the tool. Then, unplug and examine for presence of water in the outlet. See Figure 1, above.
14.Use cold water only. Never use hot water. Using hot water can damage the Pump seals.
15.Never run the Tile Saw without a water supply. Running the unit with- out a water supply will cause irrepa- rable damage to the Pump.
16.Make sure the water supply used for the Tile Saw is not dirty, sandy, and does not contain any corro- sive chemical products.
17.Make sure to change the water when necessary while in use and rinse out the Tub after every use.
18.Never leave the Tile Saw unattend- ed when it is plugged into an elec- trical outlet. Turn off the Tile Saw, and unplug it from its electrical outlet.
19.Always keep the water level at the recommended level. Fill the tray in the Body (19) until it is about 3/4 completely submerged, but do not overfill.
20.Avoid splashing water on the Motor (32), Power Switch, Power Cord/Plug, or any other electrical component. Make sure to stand on a dry, insulated surface such as a rubber mat while using the Tile Saw.
21.To avoid accidental injury, always wear heavy duty work gloves when changing the Saw Blade. Before using the Tile Saw, make sure the Saw Blade is properly and securely mounted on the Saw Spindle. Make sure the Saw Blade is balanced, and is not cracked or bent.
22.The Saw Blade will become hot while cutting. Allow the Saw Blade to completely cool before handling.
23.Allow the Saw Blade to spin up to full speed before feeding a work piece into it. When turning off the Tile Saw, allow the Saw Blade to spin down and stop on its own. Do not press against the Saw Blade to stop it.
24.Do not force the Saw Blade into the work piece when cutting. Apply moderate pressure, allowing the Saw Blade to cut without being forced.
25.Turn off the Tile Saw and allow the Saw Blade to stop on its own if the Saw Blade is to be backed out of an uncompleted cut.
SKU 3733 | For technical questions, please call | Page 6 |
