SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
V ~ | Volts Alternating Current | |
A | Amperes | |
| ||
no xxxx/min. | No Load Revolutions | |
per Minute (RPM) | ||
|
UNPACKING
When unpacking, check to make sure the following parts are included. All sizes listed below are approximate. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. Refer to parts diagram at end of manual.
Item # | Description | Qty. |
N/A | Grinder | 1 |
29 | Side Handle | 1 |
28 | Wrench | 1 |
2 | Grinding Wheel | 1 |
N/A | Spare Brushes | 2 |
Warning:
There are certain applications for which this tool was designed. Harbor Freight Tools strongly recommends that this tool not be modified and/or used for any application other than which it was designed.
All accessories must be rated for at least the RPM speed recommended on the tool’s warning label. Wheels and other accessories running over rated speed can fly apart and cause injury.
For safest operation, it is recommended that only these accessories be used with this product:
Abrasive | Flap Wheels |
Wire Brushes | Wire Wheel Brushes |
Always use an approved and proper guard when using the above mentioned accessories. Each accessory must have the correct arbor size and must fit properly on the shoulder bushing. Make sure accessories are tightened down securely.
CAUTION: NEVER INSTALL A CARBIDE TIPPED OR STEEL CIRCULAR SAW BLADE FOR USE ON THIS ANGLE GRINDER. NEVER INSTALL A WOOD CARVING BLADE, CARVING DISC WITH SAW CHAIN CUTTERS, OR A CUTTING CARVING DISC ON THIS ANGLE GRINDER.
SKU 42203 | Rev 03/01 | REV 01/04 | Page 8 |
