Wood Fence (not provided) can be mounted to the Compound Miter Saw to limit the possibility of personal injury or damage to the Moveable Cover and Frame.
2.To mount an Auxiliary Wood Fence, securely attach the Auxiliary Wood Fence (constructed of straight wood approximately 1/2” thick, 3” high, by 20” long) to the Fence (23). NOTE: The Auxiliary Wood Fence is used only when the Saw Blade
(70)is in the 0 degree bevel position (90 degrees to the Base (12). When bevel cutting (Saw Blade tilted), the Auxiliary Wood Fence must be removed.
(See Figure J, and Assy. Diagram.)
AUXILIARY WOOD FENCE
FIGURE J
INSPECTION, MAINTENANCE, AND CLEANING
1.Caution: Always disconnect the Compound Miter Saw from its electrical power supply source before performing any inspection, maintenance, or cleaning.
2.Before each use, inspect the general condition of the Compound Miter Saw. Inspect the Power Switch (82), Power Cable and Plug (93), and extension cord (if used) for damage. Check for loose screws, misalignment, binding of moving parts, broken, cracked, or improper mounting of the Saw Blade (70), broken parts and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, turn off the Compound Miter Saw immediately and have the problem corrected before further use. Do not use damaged equipment.
3.Periodically remove the two Brush Boxes (90) with a screwdriver to inspect the condition of the two Carbon Brushes (89). If the Carbon Brushes are simply dirty, you may carefully clean them with a pencil eraser. The Carbon Brushes have wear limit markings on them. You may safely use the Carbon Brushes up to the wear limit. When they have worn up to the wear limit, the Carbon Brushes must be replaced. For proper operation, the Carbon Brushes must be replaced in pairs. When replac- ing the Carbon Brushes make sure they neatly fit into their Brush Boxes (90), and
SKU 42654 | For technical questions, please call | Page 15 |
