| HEX SCREW | FRAME (#50) |
EXHAUST PORT | (#45) |
|
|
|
FIXED BAR
HEX SCREW (#45)
(#34)
LONG SCREW
CLIP WASHER (#71) BOLT (#73) WASHER (#72)
(#37)
SAW BLADE (#70)
(TEETH POINTING
TOWARD FRONT)
FIGURE E
6.Raise and hold the Frame (50) while inserting the Saw Blade (#70) onto the Shaft (62). NOTE: Make sure the teeth of the Saw Blade point toward the front of the Miter Saw, and the arrows shown on the Frame and Saw Blade point in the same direction. (See Figure E, and Assy. Diagram.)
7.Allow the Frame (50) to automatically return to its original position.
8.Place the Clip Washer (71) and Washer (72) back onto the Shaft (62). Then, re- tighten the Bolt (73) onto the Shaft.
9.NOTE: Once this procedure is completed, make sure to remove the Deep Socket Wrench and Clip Washer Wrench from the Compound Miter Saw.
Rev 07/02
SKU 42654 | For technical questions, please call | Page |
