frame as shown in Figure 5.

10.Repeat step 9 using the hole below the hand grip in the right rear frame.

11.Repeat step 9 using the holes located on the front frames just above the large bottom tray.

12.Select one of the bolts you have just installed, and thread a wing nut and washer halfway onto the bolt. Thread the wing nut on so that the flat side of the wing nut faces to the inside of the frame assembly. See detail photo.

13.Insert the metal bushings into the center of the tape roll holders.

14.Place one tape roll holder with the metal bush- ing installed onto one of the bolts. Face the tape roll holder so the flanges are nearest to the frame. Thread on a washer and wing nut to the bolt as shown in the detail photo. Tighten against the tape roll holder.

15.Repeat steps 12- 14 to install the remaining three tape roll holders.

16.Install both cutting blades (H) onto the front frames as shown in Figure 6. Mount upper blade with the cutting edge down, and lower blade with cutting edge up. Assemble using two screws, four washers, and two nuts per paper cutting blade. Carefully fit a long spring (L) on the bottom of the front edge of the lip of the paper cutting blade

(H). Secure the hooks on each end of the spring in the holes on the paper cutting blade. Repeat with the other blade. See lower half of Figure 6.

17.Attach the small side tray to the right side of the assembly using two bolts, nuts and washers.

18.Attach the towel holder to the left side of the as- sembly. Insert the ends of the rack into the holes on the side of the assembly, rotating them upward to “hook” the rack into the frame.

Figure 5. Tape Roll Holder

Bolt Assembly

Tape Roll Holder Detail Photo

Figure 6. Cutting Blade Installation.

Mount upper blade with the cutting edge down, and lower blade with cutting edge up.

L

Rear View of Complete Upper Assembly Back View.

H

REV 05/05

SKU 45146

For technical questions, please call 1-800-444-3353.

Page 5

Page 5
Image 5
Harbor Freight Tools 45146 manual Tape Roll Holder Bolt Assembly Tape Roll Holder Detail Photo