Page 6SKU 45146 For technical questions, please call 1-800-444-3353.
OPERATION
When properly set up, this masking station will hold up to 2 rolls of masking paper and up to
4 rolls of masking tape. These materials may be arranged so the masking station will dis-
pense the paper with the tape pre-applied to the edges of the paper. This paper / tape as-
sembly may be pulled out and cut from the masking station for easy and rapid use in mask-
ing workpieces for painting or other treatment.
Installing the tape rolls
1. Select any of the upper or lower pairs of
tape roll holders for installation of a new
tape roll.
2. Check to be sure that both wing nuts are
tight against the tape roll holder.
3. Press the tape roll onto the holder.
4. Check the alignment of the tape with the
paper roll.
5. If you need to adjust the position of the
tape roll, you may adjust the wing nuts.
First, move the outer wing nuts back out
of the way. Then, move the inner wing
nuts in or out until the tape is properly
aligned with the paper roll. Retighten
both wing nuts to fix the tape roll into
position.
Note: If you are using narrower paper
rolls, you may replace the long bolts with
threaded rods of the same diameter to
allow you to position the tape roll hold-
ers even closer together.
You can also adjust the position of the
paper roll to better align with the tape
rolls.
Note: Review the paper path illustration in figure 7 before installing paper or tape.
6. Position the paper roll so that the paper unwraps from the top of the roll, toward the
cutting blades of the masking station.
7. Position the tape rolls so that the sticky side of the tape will be adhered to the paper
as it passes under the springs on the cutting blades.
Side View
of round
tape roll
Tape Roll Core
Outer
Wing
Nut
The tape roll is pressed onto the holder.
The holder position may be adjusted by
moving both the inner and outer wing nuts.
Inner Wing Nut
Flange