Harbor Freight Tools 46225 operating instructions Grounding/Voltage Warning

18.Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool.

19.Use proper size and type extension cord. If an extension cord is required, it must be of the proper size and type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the tool. If you are using the tool outdoors, use an extension cord rated for outdoor use (signified by “WA” on the jacket).

20.Maintenance. For your safety, service and maintenance should be performed regularly by a qualified technician.

Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool perfor- mance.

Warning: The warnings, cautions, and instructions discussed in this instruc- tion manual cannot cover all possible conditions and situations that may oc- cur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Grounding/Voltage Warning

Warning: Before using this tool, make sure that the power cord will be plugged into an outlet which has a three-prong ground, is 120V AC, is protected by a 30 Amp circuit breaker and has a Ground Fault Interrupter.

Common household current is 110-120V. As long as the outlet used with the Tile Saw is rated from 110-120V there will be no complications using it with house- hold receptacles. Plug the tool into a 110-120V properly grounded outlet pro- tected by a 15-Amp, dual element time delay or circuit breaker.

NEVER try to plug a 110-120V tool into a 220-240V circuit, or serious complica- tions and possible injury to the operator may occur. The plugs have different shapes to prevent this.

This tool has a three-prong plug. The third round prong is the ground. Cutting off the ground will result in a safety hazard and void the warranty.

If the outlet you are planning to use is the two-prong type, do not remove or alter the grounding prong in any way. Use an adaptor and always connect the ground- ing lug to a known grounding source. It is recommended that you have a qualified electrician replace the two-prong outlet with a properly grounded three-prong outlet.

SKU 46225 For technical questions, please call 1-800-444-3353. Page 4