(88). The Platform can be adjusted up | 5. Swing the Canister Cover (89) closed. |
and down to use various lengths of nails | Then, close the Catch (64). Make sure |
from 3/4” to | the Latch closes securely. If it does not |
A. Between 3/4” and 1” Long | engage, the nail head is not in the slot in |
Nails | the upper portion of the Feed Hook (50) |
(Use top setting). | and nail shank is not in the feeder. |
B. Between 1” and |
|
Nails |
|
(Use middle setting). |
|
C. Between |
|
Long Nails |
|
(Use bottom setting). |
|
Latch (68) |
|
Catch | Canister |
(64) | Cover |
| (89) |
Canister (82)
Canister
Cover
(89)
Feed | Nails | |
Hook |
|
|
(50) |
|
|
Adjuster Plate
SHINGLE SPACING | Screw | Bracket |
| (79) | |
| (80) |
|
BOTTOM VIEW
6.To adjust the Shingle Bracket: The Bracket (79) controls roof shingle spacing. To adjust the Bracket to work with a particular width of shingles, use the accessory Hex Wrench to loosen the Screw (80) on the Bracket. Slide the Bracket to the desired spacing. Then, retighten the Screw.
General Operating Instructions
1. | Before each use, test the Tool as |
| directed in the earlier section. |
2. | If an automatic oiler is not used, add |
| a few drops of Pneumatic Tool Oil into |
Canister (82)
(86)
the tool’s airline connection before use. |
Add a few drops more after each hour of |
3.Turn the Adjuster Nut (88) clockwise to raise the Adjuster Plate (86) until its edge aligns with the embossed nail size markings on the inside wall of the Canister.
4.Place a coil of Nails around the Adjuster Plate (86) in the Nail Canister (82). See photo, above.
| continual use. |
3. | Keep all moving parts free from dirt, tar, |
| and debris. Clean and oil all moving |
| parts before each use. |
4. | Attach the Nailer to the air supply at the |
| Air Inlet (93). Start your compressor and |
| check the pressure, making sure it is set |
REV 10d
Page 14 | For technical questions, please call | SKU 67450 |
