Harbor Freight Tools 67450 operating instructions Specific Safety Instructions

using the tool that the air source has been adjusted to the rated air pressure or within the rated air-pressure range.

b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.

Save these instructions.

Specific Safety

Instructions

1.Operators and others in work area MUST wear ANSI-approved safety goggles with side shields during use. The employer is responsible to enforce the use of eye protection by the operator and others in the work area.

2.Keep fingers away from trigger when not driving fasteners to avoid accidental firing.

3.Choice of triggering method is important. Check manual for triggering options.

4.Always assume the tool contains fasteners.

5.Do not point the tool toward yourself or anyone whether it contains fasteners or not.

6.Do not actuate the tool unless the tool is placed firmly against the workpiece.

7.Respect the tool as a working implement.

8.No horseplay. This tool is not a toy and can be deadly if misused.

9.Do not load the tool with fasteners when any one of the operating controls, such

as the Trigger or Safety Nosepiece, is activated.

10.Do not remove, tamper with, or otherwise cause the tool operating controls to become inoperable.

11.Do not operate the tool if any portion of the tool operating controls is inoperable, disconnected, altered, or not working properly.

12.Disconnect the tool from the air supply when:

a.Unattended.

b.Performing any maintenance or repair.

c.Clearing a jam.

d.Moving the tool to a new location.

13.Do not make any modifications to this tool.

14.Refer to the tool maintenance instructions for detailed information on the proper maintenance of the tool.

15.Fire fasteners into an appropriate work surface only. Do not attempt to fire fasteners into surfaces too hard to penetrate. Do not drive fasteners on top of other fasteners, or at too steep of an angle. Fasteners can ricochet causing personal injury.

16.Do not fire fasteners too close to the edge of a workpiece. They may split the workpiece and fly free, causing personal injury.

17.Keep clear of the workpiece near the area being fastened. Fasteners may bend sideways during firing, causing them to exit the workpiece at an unexpected point, causing personal injury.

18.Transport tool safely. Always disconnect air supply when moving the tool. Carry

SKU 67450 For technical questions, please call 1-800-444-3353. Page 5