MITER GAUGE

(3)

MITER GAUGE KNOB

ANGLE SCALE

FIGURE K

To Adjust The Sand Belt Frame For Vertical Sanding:

Loosen the two Nuts (36) on the Sanding Belt Frame (40), and with assistance raise the Sanding Belt Frame to its full vertical position. Then, firmly retighten the two Nuts to lock the Sanding Belt Frame in place. (See Figure L.)

NUT (36)

SANDING BELT FRAME (40)

 

(VERTICAL POSITION)

FIGURE L

To Adjust The Position Of The Table:

1.When the Sanding Belt Frame (40) is in its vertical position, the Table (1) should be repositioned to the front of the Sanding Belt Frame. (See Figure M, next page.)

2.To reposition the Table (1), loosen the two Set Screws (14) and remove the Table, including the Support Bar (18). (See Figure M.)

3.Insert the Support Bar into the Mounting Hole, and tighten the other two Set Screws (14). (See Figure M.)

REV 04b

SKU 06852

For technical questions, please call 1-800-444-3353.

PAGE 13

Page 13
Image 13
Harbor Freight Tools 6852 To Adjust The Sand Belt Frame For Vertical Sanding, To Adjust The Position Of The Table