6.Once the sanding procedure is completed, remove the workpiece from the Sand- ing Belt (2), turn the Power Switch (53) to its “OFF” position, and unplug the Power Cord (55) from its electrical outlet. (See Figure B.)
INSPECTION, MAINTENANCE, AND CLEANING
1.CAUTION: Always turn the Power Switch (53) to its “OFF” position and un- plug the Power Cord (55) from its 110 volt electrical outlet before perform- ing any inspection, adjustments, maintenance, or cleaning.
2.BEFORE EACH USE, inspect the general condition of the Belt/Disc Sander. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, excessively loose Sanding Belt (2) and Sanding Disc (15), and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.DAILY: Sanding Belts (2) and Sanding Discs (15) must be sharp and clean to perform properly. Depending on materials sanded and frequency of tool use, Sanding Belts and Sanding Discs become clogged with wood particles and dull. Dull Sanding Belts and Sanding Discs rub the workpiece rather than cut, which results in increased friction, higher temperatures, and a burned workpiece. As often as possible, check the condition of the Sanding Belt and Sanding Disc and, if necessary, replace a worn Sanding Belt and Sanding Disc with a new, 6” wide by 48” Sanding Belt and 9” diameter Sanding Disc.
4.DAILY: With a soft brush, cloth, or vacuum, remove all sawdust and debris from the Belt/Disc Sander. Then, use a premium quality, lightweight machine oil to lubricate all moving parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTI- FIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 06852 | For technical questions, please call | PAGE 16 |
