turn off the machine and unplug it from its electrical outlet. Then repeat Steps #2 through #7 to further increase the tension on the Sanding Belt. (See Figures B and H.)
9.Attach the Back Stop (39) to the side of the Sanding Belt Frame (40), as shown in
Figure H.
| Back Stop (39) |
|
| |
| Sand in this area. |
|
| |
LOCK KNOB & | LOCK KNOB & |
|
| |
ADJUST NUT ASSY. | ADJUST NUT ASSY (44) |
|
| |
(44) | Sanding BELT FRAME | LOCK | ||
| ||||
SANDING BELT (2) | KNOB (44) | |||
(40) |
| |||
|
|
| ||
|
| ADJUST NUT (44) | ||
FIGURE H |
|
|
| |
To Install A Sanding Disc: | SANDING DISC |
| (15) |
1.CAUTION:Alwaysturn
| the Power Switch (53) | SANDING DISC PLATE |
| to its “OFF” position | (16) |
| and unplug the Power |
|
| Cord (55) from its 110 |
|
| volt electrical outlet |
|
| before performing |
|
| this procedure. (See |
|
| Figure B.) |
|
2. | S w i n g t h e Ta bl e |
|
| Support Bracket (9) |
|
| out of the way and | FIGURE I |
| remove the cover from |
|
|
| |
| the Pulley Cover ( 22) |
|
as explained on page 9. Check to make sure the Sanding Disc Plate (16) is free of dirt, oil, and other debris. (See Figure I.)
3.Remove the paper backing on the adhesive Sanding Disc (15), and stick the Sanding Disc firmly and evenly onto the Sanding Disc Plate (16). Restore the Table Support Bracket and Pulley Cover to their original positions. (See Figure I.)
REV 04b
SKU 06852 | For technical questions, please call | PAGE 11 |
