y fet Sa
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury from accidental operation: Release the Trigger and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
Setup
no rati Ope
ec
Maintenan
1.BEFORE EACH USE, inspect the general condition of the tool. Check for:
•loose hardware,
•misalignment or binding of moving parts,
•cracked or broken parts,
•damaged electrical wiring, and
•any other condition that may affect its safe operation.
2.After Use, wipe external surfaces of the tool with clean cloth.
3.Periodically blow dust and grit out of the motor vents using dry compressed air. Wear ANSI‑approved safety goggles and NIOSH‑approved
breathing protection while doing this.
4.Periodically recheck all nuts, bolts, and screws for tightness.
5.Remove Foam Pad from Backing Pad when Polisher/Sander is not in use. This will allow Backing Pad to dry and retain its original shape. Wash with mild soap and water before storing.
6.The Polishing Bonnet may be machine washed in cold water with mild detergent. Do not put in the dryer.
7.Use only a clean cloth and mild detergent to clean the body of the Polisher. Do not use solvents.
Do not immerse any part of the tool in liquid.
8.Over time, if the performance of the tool diminishes, or it stops working completely, it may be necessary to replace the Carbon Brushes. This procedure should be completed by a qualified technician.
9.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
Page 16 | For technical questions, please call | Item 69474 |
