(to a maximum 11” deep). To do so, remove the two Cotter Pins (39). Remove the two Pin Shafts (38). Raise or lower the Depth Skid (57) to obtain the desired tilling depth. Then, replace the Pin Shafts and Cotter Pins. (See Figure C.)
LEFT SIDE VIEW (TO LOWER) | RIGHT SIDE VIEW (TO RAISE) | ||||||
|
|
|
| DEPTH SKID (57) | DEPTH SKID (57) |
|
|
|
|
|
|
| |||
|
|
|
| ||||
|
|
|
|
|
|
| |
|
|
|
|
| COTTER PIN (39) | ||
|
|
|
|
| COTTER PIN (39) | ||
|
|
|
| PIN SHAFT (38) |
|
|
|
|
|
|
|
|
| ||
|
|
| PIN SHAFT (38) |
|
|
| |
|
|
|
|
|
| ||
FIGURE C
3.Open the Fuel Valve on the Engine.
4.Turn the Choke Lever on the Engine to its “CHOKE” position.
5.Set the Throttle Control (71) to its “FAST” position. (See Figure D, next page.)
6.Hold the Start Handle of the Engine loosely and pull it slowly several times to allow the gasoline to flow into the Engine’s carburetor. Then hold the Start Handle firmly and pull the rope hard and fast. Pull the rope all the way out, using two hands if necessary. If necessary, pull the rope several times until the Engine starts.
7.Allow the Engine to run for several seconds. Then, turn the Choke Lever to its “RUN” position.
8.Adjust the Throttle Control (71) to the desired speed at which the Cultivator will move. (See Figure D.)
9.Grip the Upper Handle (66) firmly with both hands. (See Figure D.)
10.Squeeze down on the Clutch Handle (73) to rotate the Tines (37, 50, 40) and move the Cultivator in a FORWARD direction. (See Figure D.)
11.Slowly push the Cultivator while guiding the tool in the desired forward direction.
SKU 91959 | For technical questions please call | PAGE 10 |
