UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 18 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 19.
CAUTION: Always make sure the Power Cord of the Tile Saw is unplugged from its electrical outlet prior to making any adjustments to the tool.
1.Find a level surface capable of supporting the Saw. If the surface is not level, the water level may inadvertently fall below the recommended level at the blade, causing serious damage and possibly, severe injury.
2.To install the Blade (42), lift the Bevel Table (3) and swing out the arm and rest it in the groove to keep the table up. With a screwdriver (not included), and a wrench, loosen and remove the Arbor Nut (40) and the Outer Flange (41).
3.Make sure the Blade (42) rotation is the same as illustrated on top of the Bevel Table (3). Fit it snug against the Inner Flange (43), then snug up the Outer Flange (41) and the Arbor Nut (40). See FIGURES 1 and 2 below, and FIGURE 3 on page 14.
FIGURE 1
FIGURE 2
Bevel Table (3)
Support Arm
Loosening and removing the Arbor Nut (40)
SKU 92658 For technical questions, please call | Page 13 |
