8.Always unplug the Tile Saw from its electrical outlet before perform- ing any inspection, maintenance, or cleaning procedures.
9.This product must continuously run with cold water. Never use hot water.
10.WARNING! Keeps hands and fingers away from cutting area and Saw Blade. Use an appropriate “push stick” (not included) when necessary.
11.Check Blade Guard for proper forward/backward movement before each use. Do not operate the Tile Saw if the Blade Guard does not move freely. Make sure the Blade Guard moves freely and does not touch the Saw Blade or any other part of the Saw, in all angles and depths of cut.
12.Make sure the Tile Saw is located on a flat, level, sturdy surface capable of supporting the weight of the Saw and workpieces.
13.Always use Diamond Saw Blades with a 7” diameter, 5/8” round arbor hole, and rated at 3600 RPM or greater.
14.Use the Tile Saw only for cutting ceramic tile, quarry tile, marble, terra cotta, and slate with a maximum thickness of
15.Do not use the Tile Saw for cutting metals or for cutting curves. This may cause the Saw Blade to break and/or reduce its service life.
16.Make sure the Saw Blade is wet at all times when cutting.
17.To reduce the risk of electrocution, keep all electrical connections dry and off the ground. Do not touch the plug with wet hands.
18.To avoid the possibility of the appliance plug or receptacle getting wet, position the Tile Saw to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or plug. Always arrange a “drip loop” in the Power Cord connecting the Tile Saw to a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power Cord below the level of the outlet, or the connector if an extension cord is used, to prevent water traveling along the Power Cord and coming in contact with the outlet. If the Power Plug or electrical outlet does get wet, do not unplug the Power Cord. Disconnect the fuse or circuit breaker that supplies power to the tool. Then, unplug and examine for presence of water in the outlet.
19.If the plug or receptacle does get wet, do not unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the tool. Then unplug and examine for presence of water in the receptacle.
20.Do not handle the Power Switch with wet hands.
21.To avoid accidental injury, always wear heavy duty work gloves when
changing the Saw Blade. |
|
SKU 92658 For technical questions, please call | Page 6 |
